Dalsa 1M60 User Manual download pdf (Page 9)

1M60 Camera User’s Manual 9

DALSA C32-10010-01

2.3

LED Status Indicators

There are four LED’s visible on the rear cover of the camera that indicate the status

of the camera.

Table 4. LED Functions

LED Label Color LED “ON” LED “OFF”

ON Green Camera is receiving power There is no camera power

POST Green Camera Power On Self Test successful Camera failed Power On Self Test

BIN Red Camera is operating in a binning mode Camera is operating unbinned

(1x1)

MODE Red Camera is in an external trigger mode (uses

external signal to trigger image capture)

Camera is triggering image

capture internally

2.4

Power Input

Table 5. Power Connector Pinout

Pin Symbol

1 +5V

The camera has the following input power

requirements.

2 +5V

3 - 5V

4 +15V

(DC)

±%

Max

Ripple

5 NC

+15 0.5 < 5 0.45

6 NC

+5 0.5 < 5 1.88

7 GND

-5 0.5 < 5 0.58

8 GND

9 +5V

10 - 5V

11 +15V

12 NC

13 NC

14 GND

15 GND

DB15M

(AMP Part # 747236-4

or equivalent)

Note: Performance specifications are not

guaranteed if your power supply does not

meet these requirements.

Many high quality supplies are available

from other vendors. DALSA assumes no

responsibility for the use of these supplies.

When setting up the camera’s power supplies, follow these guidelines:

• Do not connect or disconnect cable while power is on.

• Do not use the shield on a multi-conductor cable for ground.

• Keep leads as short as possible to reduce voltage drop.

• Use high-quality linear supplies to minimize noise.

WARNING: It is

extremely important

that you apply the

appropriate voltages to

your camera. Incorrect

voltages will damage

the camera.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Comments to this Manuals

No comments

Dalsa 1M60 User Manual Page 9

Comments to this Manuals

Related products and manuals for Bridge cameras Dalsa 1M60